Parameters and specifications
frequency range | 0.01 to 100 MHz |
rated output power | 110 W guaranteed (140 W typical) |
output power at 1 dB compression | 90 W guaranteed (100 W typical) |
amplification | 51 dB |
harmonics at P1 dB | better than -20 dBc |
supply voltage | 85-264 VAC, single phase |
- CBA 100M-110 low-frequency amplifier can be used in conjunction with other Teseq amplifiers to cover the entire frequency range from 10 kHz to 40 GHz with enough frequency overlap to allow you to optimize the power level in each range
- class A ensures high reliability and linear performance with low distortion over the entire frequency range, this design also ensures that the amplifier will operate at full power, even when previously connected to empty or short-circuited
- the amplifier is powered from a high efficiency, high power factor switching power supply that allows operation over a wide voltage range, the unit is air-cooled with integrated fans and is protected against faulty cooling by sensing excessive temperature, there is a safety interlock connector that the user can short to the carcass to place the amplifier in standby mode, there are indicators on the front panel to indicate overtemperature and RF lockout functions
- most commonly used for IEC/EN 61000-4-6, CISPR 24, EN 61000-6-1, EN 61000-6-2, IEC 60533, IEC 60601-1-2, IEC 61326, MIL STD 461, RTCA/DO 160, ISO 11452-3, ISO 11452-4, ISO 11452-5, SAE J1113-4, SAE J1113-24 standards
Downloads and links
- Brožura Teseq CBA Series BROADBAND POWER AMPLIFIERS.pdf (5103.3kB)
- Tabulka Teseq CBA Series BROADBAND POWER AMPLIFIERS.pdf (843.2kB)
- Datasheet - CBA100M-110.pdf (493.4kB)
- Further information on the manufacturer's website
Need some advice?
Call us on +420 325 610 123 and ask for a specialist in this field.