Discount

CCI Capacitive Coupling Clamp DEMO

capacitive coupling clamp
date of manufacture 12/2022
design according to IEC 61000-4-4 Ed.3
EFT/Burst testing of signal and data lines
active coupling length 1 m
permissible surge voltage (burst) 7 kV
for cable diameters up to 40 mm
calibration kit for capacitive coupling clamps according to IEC 61000-4-4 Ed.3 (as optional accessory)
extension for PVF BKIT 1 for calibrating capacitive coupling clamps with EFT/burst
flexible sensor plate 1050 x 120 mm (optional accessory)
warranty: 1 year

Parameters and specifications

maximum test voltage	7 kV
coupling plate dimensions	140 mm x 1000 mm
height	ground plate – coupling plate, 100 mm
connector	HV coaxial connector
ground conductor connection	4 mm banana plug
tested cable diameter	max. 40 mm
weight	10.6 kg

CCI is used to couple EFT/burst pulses onto I/O lines as required by various European and international immunity testing standards.

Coupling of electrical fast transients (EFT/burst) onto signal lines usually cannot be achieved by discrete capacitive coupling without disturbing signal transmission. In many cases, it is not possible to connect directly to the circuit under test, for example via coaxial or shielded cables. In such cases, coupling is performed using a capacitive coupling clamp.

The interference simulator can be connected on either side of the coupling clamp. The standard IEC 61000-4-4 ed. 3.0, published in 2012, recommends calibration of the capacitive coupling clamp into a 50-ohm coaxial load using the normative calibration set CCI PVKIT 1.

Call us on +420 325 610 123 and ask for a specialist in this field.