CVP 2200A Capacitive Voltage Probe

    • capacitive voltage probe
    • in accordance with CISPR 22 (EN 55022), CISPR 32 (EN 55032) and CISPR 16-1-2
    • battery or DC power supply (DC power supply not included)
    • switchable conversion factor
    • shielding to reduce direct capacitive coupling from cables near the probe
    • calibration fixture included
    • warranty: 2 years
    Ametek Compliance Test Solutions
    Other parameters
    Price on request
    Cat. no: CVP2200A.w
    availability on request

    No item matches your selection.

    Parameters and specifications

    frequency range

    150 kHz to 30 MHz
    correction factor k1 (only valid for 22 mm cable diameter)

    A3:
    A2:
    A1:

    20 dB
    30 dB
    40 dB
    frequency response correction factor k1

    A3:
    A2:
    A1:

    ±1.2 dB
    ±0.8 dB
    ±0.8 dB
    power supply

    internal
    External

    6 x 1.2 V, NiMH battery, e.g. 1700 mAh
    Linear power supply, 230 VAC / 9 VDC DC (not included)
    current, type 180 mA
    battery operation (typical) 8 h
    cable size

    max
    min

    32 mm

    5 mm

    connectors
    output to test receiver BNC 50 Ω, female
    input for power supply jack bush, ∅ 3.5 mm
    • capacitive voltage probe (CVP) is designed for measuring asymmetrical interference on cables based on the capacitive coupling principle
    • provides the possibility to perform measurements without disconnecting the cable under test and thus prevents unwanted transients
    • the main parameter of the CVP is the coupling factor, measured in a calibration system with an impedance of 50 Ω
    • the capacitive voltage probe is specified in Section 5.2.2 and Annex G of CISPR 16-1-2.
    • The capacitive voltage probe (CVP) is used for measurements at telecommunication ports for lines with more than four symmetrical pairs or for unsymmetrical lines

    Downloads and links

    Need some advice?

    Call us on +420 325 610 123 and ask for a specialist in this field.